SnowFox Creations

Buy Item Here: Listing at Etsy

This is an ‘iCritter’ iPod case from Snow Fox Creations. I make these by hand individually, and each one has many features including:

* clear plastic protects the screen and controls while allowing full access to them

* small opening in plastic at bottom of case to allow full access to USB port for charging and syncing (the hole is small enough that there is absolutely no risk of the iPod falling out)

* back of the case closes with velcro and has back made from no-fraying ribbon

* secure case is made from canvs-backed fake fur and is held together by upholstery thread + tons of hot-craft-glue. I used several sticks in the hot glue gun for this- it is NOT going to fall apart. It’s the same type of case I use for my own iPod and is very secure.

* The “face” of the fox lift up to allow access to the earbud port and hold switch. In normal use, the earbud cord will trail out from beneath the face and willpermit use, while hiding the base of the earbud cord (which, in my opinion, is rather ugly- but Steve Jobs has different tastes.)

* The fox has a fur tail, pipe-cleaner whiskers and felt facial features- including its mischievous smiling face. >^_^< Its legs and ears are made from 2 (in the case of the ears, 3) layers of felt glued together with hot craft glue. Once hot glue dries, it's pretty much indestructible. (I found this out in a rather painful way. If you use hot glue, keep it OFF of your fingers!)

* The ends of the adjustable strap are sealed with no-fray sealant, in addition to being tied with thread and over themselves, to prevent fraying.

* BTW, the fur is ***FAKE***. I wouldn't take it from an animal! D: No little animals were harmed by this.

So, I present an iPod case that is both cute and nearly indestructible. Please give this sweetie a good home! >^_^<

Buy Item Here: Listing at Etsy